Installing the Serial PCI Interface Card (VScom)

 Tips:  

The serial VScom PCI interface card is no longer available from Dionex. However, as serial VScom PCI interface cards may still be used in the field, refer to the corresponding installation instructions below.

This card is not supported under Windows Vista or later.

Installing the Card

• Turn off the PC and disconnect the power cord.

• Remove the PC housing and find a free PCI slot. Carefully insert the card into the free PCI bus slot.

• Replace the PC housing, reconnect the power cord, and turn on the PC.

For more information about how to install the VScom PCI interface card, refer to  Installing the VScom Card under Windows XP. Also, see  Installing the Serial PCI-Interface Card (Equinox).

If problems arise during installation, refer to  Troubleshooting for possible remedial actions.